www.phocos.com 51 | P a g e
Warning code 69
Battery charging
temporarily disabled by
battery management
system.
Battery is not allowed to charge as
the battery manag ement system
(BMS) in the connected battery has
blocked charging due a BMS or
battery cell error.The Any-Grid will
stop charging the battery.
Warning code 70
Battery disc harging
temporarily disabled by
battery management
system.
Battery is not allowed to discharge
as the battery management syste m
(BMS) in the connected battery has
blocked discharging due a BMS or
battery cell error.The Any-Grid will
stop discharging the battery.
Fault code 71
The firmware version of
each inverter is not the
same.
1. Check the version of each
inverter firmware via t he screen
and make sure the versions are
same. If not, contact your
instraller to provide a firmware
update.
2. After updating, if the problem
still remains, please contact
your repair center.
Fault code 72
The output current of each
inverter is different.
1. Check if the green current
sharing cables are correct ly
connected and restart the unit.
2. If the problem remains, please
contact your repair center.
Fault code 80
CAN c ommunication data
loss
1. Check if the grey
communication cables are
correctly connected betwe en all
units and restart the units.
2. If the problem remains, please
contact your repair center.
Fault code 81 Host data loss
Fault code 82 Synchronization data loss
Fault code 83
The detected battery
voltage differs between
units .
1. Make sure all inverters share
same battery bank.
2. Remove all loads and
disc onnect AC input and PV
input. Then, check the battery
voltage of all units. If the values
from all inverters are close,
please check if all battery cables
are the same length and s ame
material and cross-section.
Verify the seat of each battery
connaction to the respective
units .
3. If the problem s till remains,
please contact your repair
center.
To Next Page
Loading...
Need help?
General
