Phonak Roger Select iN User Manual

28 29
7.2 Connecting Roger Select iN to your Roger receiver
The Roger receiver can either be installed into your
hearing aid, attached to your hearing aid / sound
processor or body-worn (Roger MyLink or Roger X
plugged into your streamer).
Connect the Roger receiver(s) as follows:
1. Turn on your Roger microphone and Roger receiver.
2. Hold your Roger microphone close (within 10 cm/
4inches) from the Roger receiver.
3. Press the Connect button on your Roger
microphone.
The back indicator light will turn green for two seconds to
conrm a successful connection.
Connect status lights
After pressing the Connect button, the following feedback
may be given by the back indicator light:
Connecting
Connection was successful – your Roger receiver is
connected to your Roger microphone.
Your Roger microphone could not nd a Roger receiver.
Move the devices closer to your Roger receiver and
make sure the Roger receiver is powered on. Then try to
connect again.
The Roger receiver is not compatible with your
Roger microphone.
You can connect an unlimited number of Roger
receivers to your Roger microphone, simply repeat
step 2 and 3 for any other Roger receiver.

Phonak Roger Select iN Specifications

General

Brand	Phonak
Model	Roger Select iN
Category	Microphone
Language	English