32 33
Connect status light
After pressing the Connect button, the following feedback
may be given by the back indicator light:
Connection was successful - the other Roger microphone
is now connected to your Roger Select iN.
Roger Select iN could not nd another Roger
microphone. Move Roger Select iN closer to the other
Roger microphone and make sure both microphones are
switched on. Then try Connect again.
The other Roger microphone is not compatible with your
Roger Select iN or the other Roger Select iN’s Bluetooth
is still enabled. Please update the software of your Roger
microphones or disable Bluetooth on the secondary
Roger Select iN.
8.2. Using multiple microphones
When Roger Select iN is used with other microphones, it
has to be worn by a talker on the chest. When you place
Roger Select iN on the table, it will mute automatically.
Unmuting Roger Select iN will mute the other
microphones that are connected with the Roger Select iN.
Muting Roger Select iN or wearing it on the chest will
reactive the other microphones again.
To Next Page
Loading...
