Phottix Laso - Page 24

24
3.1 Press function button 4 until is
displayed.
3.2 Set a channel: Press function button 1
corresponding to
turn < > to
select from Ch. 1-15 or Auto, and press <
> button to nish the setting.
3.3
Set wireless radio ID: Press function
button 2 corresponding t o , turn <
> to select the digit to be set and press
<
> button. Again turn < > to select
a number from 0-9, and press the < >
button.
3.4 Repeat step 3.3 to set the four ID digits
one by one. Press function button 4 for
corresponding to
to return to the
shooting-ready state.
3.5 When the transmission between the
master unit and slave unit is established,
the <
> lamp lights green.
4. Scanning the Master Unit Transmission
Channels to Set
Phottix Laso Transmitter is able to scan the
radio reception status and set the master
unit’s transmission channel automatically or
manually. When the channel is set to “AUTO”,
the channel with the best reception signal is
automatically set. When setting the channel
manually, you can set the transmission
channel again while referring to the scan
results.