46
3 corresponding to , turn < >
to select the digit to be set, and press
<
> button. Again turn < > to select
a number from 0-9, and press the < >
button. Repeat the procedure to set the 4 ID
digits one by one. Press function button 4
for corresponding to
to return to the
shooting-ready state.
3. Set the camera’s shooting functions
4. Set all the Transmitters
Repeat steps 1to3 and set all the Transmitters
to “Master unit” or “Slave unit” in the linked
shooting mode.
Set the Speedlites used in linked shooting in
the same way.
When pressing linked shooting button to
change the setting of a unit from “Slave unit”
to “Master Unit”, the other Transmitter (or
Speedlites) that were set to “Master Unit” until
then automatically switch to “Slave unit.
5. Set up the slave unit cameras
Check that the <
> lamp of the slave
unit lights green and place all the slave units
within master unit’s the radio transmission
range.
6. Take the pictures
Check that the <
> lamp of the master
unit lights green and take the picture.
The slave unit cameras are released in
coordination with the master unit camera.
After shooting with linked shooting, the
To Next Page
Loading...
