EasyManuals Logo

Physik Instrumente C-863 Mercury User Manual

Physik Instrumente C-863 Mercury
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
Introduction
Max. relative humidity 80% for temperatures up to 31°C, decreasing linearly
to 50% relative humidity at 40°C
Line voltage fluctuations not greater than ±10% of the line voltage
Transient overvoltages as typical for public power supply
Note: The nominal level of the transient overvoltage is the standing surge voltage according to the
overvoltage category II (IEC 60364-4-443).
Degree of pollution: 2
1.3 Safety Precautions
Read carefully the documentation of the included software components and of the
mechanics used also. Failure to heed warnings in this manual can lead to
accidents causing bodily injury, damage to equipment or loss of warranty
protection. Note that the C-863 does not contain any user-serviceable parts.
WARNING
All motion of the connected motors and mechanical stages is software
controlled, and software may fail. Be aware that motorized stages generate
large forces that may cause personal injury or other damage if mishandled.
!
CAUTION
Install and operate the C-863 controller only after you have read the operating
instructions. Keep the manuals and any relevant Technical Notes readily
available. If lost or damaged, new copies can be downloaded from www.pi.ws
or obtained from PI.
!
CAUTION
If operating different Mercury™ controllers, do not mix up the 12 V, 15 V and
24 V power supplies!
www.pi.ws C-863 MS173E Release 1.2.7 Page 5

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Physik Instrumente C-863 Mercury and is the answer not in the manual?

Physik Instrumente C-863 Mercury Specifications

General IconGeneral
BrandPhysik Instrumente
ModelC-863 Mercury
CategoryController
LanguageEnglish