PIAGGIO ZIP 4T User Manual

Name: PIAGGIO ZIP 4T
Brand: PIAGGIO
Rating: 5 (1 reviews)

192 pages

To Next Page

To Previous Page

- Fit a new oil seal on the outer rim with the help of

the specific tools below.

- Fit a new O-ring and lubricate it with grease.

- Install the cover on the engine crankcase, insert

the three screws and place the cover in its position.

- Tighten the 3 screws to the prescribed torque.

Specific tooling

020376Y Adaptor handle

020358Y 37x40-mm Adaptor

Locking torques (N*m)

Timing chain/oil pump compartment cover

screws 4 ÷ 5 Nm

Oil pump

Removal

- Remove the chain compartment cover undoing

the 3 fixing screws indicated in the figure.

- Take out the cover using the appropriate fusion

couplings on the cover with a pair of pliers

- Undo the 2 clamping screws in the figure and re-

move the cover over the pump control crown gear.

- Block the rotation of the oil pump control gear with

a screwdriver inserted through one of its pump

holes.

Engine MSS ZIP 100 4T

ENG - 112

Questions and Answers:

Need help?

Do you have a question about the PIAGGIO ZIP 4T and is the answer not in the manual?

General