PIAGGIO ZIP 4T - Transmission, Clutch, and Drive Belt

Automatic transmission
Transmission cover
- Remove the 12 fixing screws.
- Remove the oil filling cap and then slide out the
cover.
If this operation is carried out directly on the vehi-
cle, it is necessary to remove the transmission
cooling coupling and the air filter housing retain-
ers.
N.B.
USE A MALLET ON THE APPROPRIATE COUPLINGS TO
REMOVE THE COVER.
Kickstart
-To remove the start up pinion push the starter
lever to facilitate extracting the pinion.
-Remove the kick-start screw and lever.
-Remove the Seeger ring and the washer indica-
ted in the figure.
-Pull out the toothed sector.
WARNING
THE SECTOR KEEPS THE SPRING SET, BE CAREFUL SO
AS NOT TO CAUSE ANY ACCIDENTS
Air duct
- To remove the intake throat on the transmission
cover, just remove the three fixing screws indica-
ted in the figure.
Engine MSS ZIP 100 4T
ENG - 66