PIAGGIO ZIP 4T User Manual

Check
- Park the scooter on level ground and rest it on
the centre stand.
- Unscrew the dipstick «A», dry it with a clean rag
and then reinsert it, screwing it tightly into
place.
- Take out the dipstick checking oil level is between
the second and third notch from the bottom (MAX
and MIN shown in figure).
- If the level is under the MIN notch, refill the hub
with the right amount of oil.
- Screw up the oil dipstick again and make sure it
is locked properly into place.
Recommended products
AGIP ROTRA 80W-90 Rear hub oil
SAE 80W/90 Oil that exceeds the requirements of
API GL3 specifications
Replacement
- Remove the oil filling cap/dipstick «A»
- Unscrew the oil drainage cap «B» shown in the
figure and drain out all the oil.
- Screw the drainage cap back and fill up the hub
with the required oil (about 80 cc)
MSS ZIP 100 4T Maintenance
MAIN - 31

PIAGGIO ZIP 4T Specifications

General

Cooling System	Air-cooled
Fuel System	Carburetor
Front Suspension	Telescopic fork
Rear Suspension	Hydraulic shock absorber
Front Brake	Disc
Rear Brake	Drum
Seat Height	765 mm
Length	1, 700 mm
Width	680 mm
Engine Type	Single cylinder, 4-stroke
Transmission	CVT
Top Speed	45 km/h
Max Power	2.6 kW at 7, 500 rpm
Weight	89 kg (dry)