1. Transport and storage
DANGER OF DAMAGE !
1.1. Surface Protection
Machine parts are protected against corrosion by powder coating or a primer and two-component polyurethane varnish. Sliding
surfaces are coated with anti-corrosive oil. Surfaces of other parts and components of the machine are treated by galvanization or
blackening.
1.2. Packing
The basic feature of the package is a wooden frame, which can take the form of wood cladding or an overseas case. The distance
between the package and the floor is approximately 100 mm, which enables handling by a forklift. The machine is packed in a
stretching foil that protects it against weather influence during transport.
Standard accessories:
• 1 pc. metal saw blade, bimetal M42 (mounted),
• 1 pc. band saw instruction manual,
• 1 length stop.
1.3. Disassembly / Repacking
Disconnect the machine from the mains empty and clean the metal chip tank and the coolant tank clean the machine apply
anticorrosive oil on the sliding surfaces fix the arm for transport lift the machine and screw on the wooden frame observe the
distance of approximately 100 mm from the ground for the transport with the forklift make sure that all protective covers
of the machine are in place and fastened add the machine accessories.
Caution: used coolants belong to the category of special waste!
Only a person with adequate electrician qualifications can disconnect the machine from the
mains!
1.4. Disposal
When the machine has been definitely put out of operation, it should be disposed of in accordance with the provisions valid in the
respective country. We recommend that you contact a specialist waste disposal service.
2. Technical Data
Machine noise - measured in conformity with ČSNEN ISO 3746:2011
The acoustic pressure level at the workplace: 76 dB (A), acoustic power level: 91 dB (A).
The measured values exceed the value specified in the Government Regulation No. 176/2008, section 1.7.4.2, article u) and
therefore ear protection must be used during the machine operation. The measurement was carried out while the machine was in a
steady state and the saw blade speed was 80m/min. During the operational state with a technical load, the most frequently used
technological process was measured. Noise levels measured on the machines may vary depending on the type of cut material, saw
blade speed and other factors.
You can transport and lift the machine only with a forklift. THE USE OF A CRANE PROHIBITED!
To Next Page
Loading...
