PNOZ X3
Operating Manual PNOZ X3
20547-EN-10
5
INFORMATION
This gives advice on applications and provides information on special fea-
tures.
Safety
Intended use
The safety relay PNOZ X3 provides a safety-related interruption of a safety circuit.
The safety relay meets the requirements of EN 60947-5-1, EN 60204-1 and VDE 0113-1
and may be used in applications with
} E-STOP pushbuttons
} Safety gates
The safety relay can be used as a safety component for lifts:
} On existing plants in accordance with Annex IV of the directive 95/16/EC and EN81-1
and
} On new plants in accordance with Annex III of the directive 2014/33/EU, EN 81-20 and
EN81-50.
These devices can also be used as a safety component:
} For lifts with an inclined travel path in accordance with EN 81-22 and
} For escalators and moving walks in accordance with EN 115-1.
The following is deemed improper use in particular
} Any component, technical or electrical modification to the product,
} Use of the product outside the areas described in this manual,
} Use of the product outside the technical details (see Technical details [ 16]).
NOTICE
EMC-compliant electrical installation
The product is designed for use in an industrial environment. The product
may cause interference if installed in other environments. If installed in other
environments, measures should be taken to comply with the applicable
standards and directives for the respective installation site with regard to in-
terference.
To Next Page
Loading...
Need help?
General
