Pilz PNOZmulti 2

Servicedata
OperatingManualCommunicationinterfaces
1002971EN03
66
Thefollowingexampleillustratestheprocedureforselectingcertainservicedata.
Intheexample,thedevicedataforthebaseunitisselectedwiththefieldbusmodule
PROFINET.
Which data area?
Which device?
Which addressing type? Profinet records
Base unit
Device data
Selection:
Example:
Dataarea: Devicedata
Device: Devicedataaddressingonbaseunit
Addressingtype
INFORMATION
Theservicedataisonlyupdatedpiecemealineachcyclebythe
PNOZmulti.
Updatingallofthedatacantakeupto500ms.
Anexceptionisdatarequestedintableform.Thisisupdatedfullyineach
cycle.
8.1 Processdata:Baseunitandexpansionmodules
Theprocessdataofthebaseunitandexpansionmodulesconsistsof36Bytesandcon
tainsthefollowinginformation:
} Stateoftheinputsandoutputs
} ThestatusofthesystemLEDfor
– supplyvoltage,
– Diagnostics
} Stateoftheinputsandoutputs,whichisdisplayedonthedevice.