MACHINE PREPARATION
22. ASSEMBLING THE BRUSH (BASES WITH DISC BRUSHES)
sert it in the holes of the handle (2) to prevent the
lever slipping.
2. means of the pedal or key (AU version).
3. anticlockwise (to "0FF") and remove it from the start-up switch (4).
4. e the brushes into the plate housing beneath the base,
ree pins enter the niches in the plate itself; turn until
the pin is pushed towards the coupling spring and is locked into place. The figure
shows the rotation direction for coupling the right-hand brush; for the left-hand one,
1. Use the parking brake handle (1) to stop the machine. Unthread the pin (3) from
its seat on the handlebars, and in
Raise the base by
Turn the key
With the base up, plac
turning the brushes until the th
rotate in the opposite direction.
people or objects near the brushes
ATTENTION: this operation must be carried out wearing
gloves to protect your hands
ATTENTION: during this operation, check there are no
5. You are advised to invert the right and left-hand brushes every day. If the
brushes are not new however, and have deformed bristles, it is better to
reassemble them in the same position (the right-hand one on the right, and the
left-hand one
producing an
on the left), to prevent the different inclination of the bristles
overload on the brush motor as well as excessive vibrations.
1
3
2
4
23. ASSEMBLING THE BRUSH (BA L BRUSHES)
1. Use the parking brake handle (1) to stop the machine. Unthread the pin (3) from
its seat on the handlebars, and insert it in the holes of the handle (2) to prevent the
lever slipping.
2. Raise the base
3. Turn the key "0FF") and remove it from the start-up switch (4).
1
2
3
4
SES WITH CYLINDRICA
by means of the appropriate pedal.
ticlockwise (toan
ATTENTION: The following operations must be carried out
using protective gloves.
15
To Next Page
Loading...
