6. EXCESSIVE FOAM PRODUCTION
Check that a low foam detergent has been used. If necessary, add a small quantity of
antifoam liquid to the recovery tank.
generated. In this case
Remember that, when the floor is not very dirty, more foam is
the detergent solution should be more diluted.
7. ELECTRIC FUSES AND THERMAL CUT-OUTS
Po ged in the electrical box, to protect against short-circuiting
motors:
1.
2.
verheats, its thermal cut-out intervenes to block the electricity supply. Wait a few
minutes until it has cooled down, then press the specific trip unit button to reactivate the
power supply and motor operation.
The machine is fitted with the following electrical protection systems:
wer fuses arran
thermal trip units arranged on the outside of the handlebars, to protect the following
30A trip unit (1) for the base motor
20A trip unit (2) for the suction motor
In the event of malfunctioning, check a thermal cut-out has not intervened. If the motor
o
1
2
27
To Next Page
Loading...
