The front rubber (3) should be replaced when the s ly on the
floor and does not generate a closed suction chamber (letting a lot of air enter from the
(4) that block the front rubber-pressing blade.
7. e front rubber (3) and the rubber-pressing blade, then tighten the
queegee does not rest even
front). To replace the rubber, you must:
4. Disassemble the squeegee from its support (see the “DISASSEMBLING AND
CLEANING THE SQUEEGEE” paragraph).
5. Loosen the threaded nuts
6. Unthread the front rubber (3) and replace it.
Reassemble th
threaded nuts (4).
ATTENTION: These operations must be carried out using gloves
tact with dangerous solutions to protect against con
TROUBLESHOOTING
3. INSUFFICIENT WATER ON THE BRUSH
4. Check the tap beneath the symbol (1) is turned on.
5. Check there is water in the solution tank.
4. THE MACHINE DOES NOT CLEAN WELL
1. heck the state of wear and tear of the bC rush and, if necessary, replace it (the
b are about 15mm long).
2. Use a different kind of brush to the one fitted as standard. For cleaning floors where the
dirt is particularl
request and acco SHES”).
rush must be replaced when the bristles
y resistant, we recommend the use of special brushes supplied upon
rding to needs (see “CHOOSING AND USING THE BRU
1
3
4
5. THE SQUEEGEE DOES NOT DRY PERFECTLY
.
Adjust the inclinat (see the “ADJUSTING THE
SQ
Check the suction tube is correctly tank.
Check the inner filter of t , clean it thoroughly.
1. Check the squeegee rubbers are clean
2. ion and height of the squeegee
UEEGEE INCLINATION AND HEIGHT” paragraph).
3. inserted in its housing on the recovery
4. he recovery tank is not dirty and, if necessary
26
To Next Page
Loading...
