DAILY M ANCE AINTEN
1. CLEANING THE RECOVERY TANK
Raise the suction1. ver and keep it still using the lifting rod (1) at the side.
3.
4.
5. e machine and replace the drainage hose cap.
co
2. Remove the drainage tube (2) from its seat.
Remove the cap and empty the tank.
Rinse the inside of the tank well with a jet of water.
Reposition the cover on th
ATTENTION: These operations must be carried out using gloves
to protect against contact with dangerous solutions.
2. CLEANING THE SUCTION FILTER
. Raise the cover (1), blocking its stroke with the clamp (2).
2. Remove the suction filter protection (3) by rotating it clockwise.
3. Remove the suction filter (4) from its seat.
4. Use a jet of water to clean the walls and base of the filter.
.
1
5. Reassemble all the elements
ves
to protect against contact with dangerous solutions.
ATTENTION: These operations must be carried out using glo
3. CLEANING THE SUCTION TUBE FILTER
1. Raise the suction cover and block it as indicated in the previous paragraph.
1) and remove it. 2. Rotate the inner filter (
3. Carry out the cleaning operations carefully.
4. Reassemble all the elements.
ATTENTION: These operations must be carried out using gloves
to protect against contact with dangerous solutions.
1
1
2
1
2
3
4
21
To Next Page
Loading...
