W EEKLY MAINTENANCE
1. NING THE SQUEEGEE TUBE
y, check the squeegee tube
the sleeve on the squeegee.
tank.
m the rubber-holder connector (3) of the
4. f water (from the tank side).
CLEA
Every week, or whenever suction seems to be unsatisfactor
is not obstructed. To clean it, proceed as follows:
1. Remove the tube from
2. Open the recovery
3. Remove the other end of the tube (2) fro
recovery tank.
Wash the inside of the tube with a jet o
5. Reassemble the tube.
2. CHECKING THE WHEEL BRAKE
Every week, check the distance between the work brake pads and the wheels. If necessary,
adjust them by means of the nuts, so they are at a distance of 3mm when homed.
3.
1.
3.
Reassemble the filter and tighten the cap.
5. Turn on the ta
CLEANING THE SOLUTION FILTER
Turn off the tap beneath the symbol (1).
2. Loosen the cap (2) of the solution filter.
Remove the filter and rinse with a jet of water.
4.
p beneath the symbol (1).
ATTENTION: These operations must be carried out using gloves
to protect against contact with dangerous solutions.
4. CLEANING THE SOLUTION TANK
6. Loosen the front cap of the solution tank.
7. Loosen the wing nut of the drainage cap (1) to the left of the tank, and remove the cap.
. Rinse the inside of the tank with a jet of water.
9. Insert the cap in the tank, and retighten the wing nut (1).
8
ATTENTION: These operations must be carried out using gloves
to protect against contact with dangerous solutions.
2
1
2
3
1
24
To Next Page
Loading...
