AT THE END OF THE WORK
1. AT THE END OF THE WORK
At the end of the work, and before carrying out any type of maintenance:
3. Raise the base by means of the pedal (2) or the key (6) (automatic version).
4. Raise the squeegee by
When the squeegee is up, the suction mo
5. Bring the machine to the plac
. Turn the key sw (to "OFF") to switch off the machine.
means of the lever (3) or the key (4) (automatic version).
tor switches off automatically.
e provided for draining the water.
itch (5) anticlockwise 6
7. nd block it with the pin (7).
. The squeegee must be raised when the machine is not operating in order to avoid
deforming the r
10. Disassemble th
brushes, see D
Pull the brake lever a
8. Remove the drainage hose (8) from its compartment, unscrew the drainage cap (9)
and empty the recovery tank.
9
ubber blades.
e brushes and clean them with a jet of water (to disassemble the
ISASSEMBLING THE BRUSHES” below). “
11. Remove the debris hopper and clean it well with a jet of water.
(SIMPLA 50SBT)
ATTENTION: These operations must be carried out using gloves
to protect against contact with dangerous solutions.
12. ed place. Raise the squeegee and
Do not leave the squeegee and brush base re
At the end of the work, park the machine in a clos
brush base using the reference lever or the specific key (AU version), then turn the key
switch anticlockwise and take out the command key. Apply the parking brake and block
the handle with the pin (1), inserting it in the lever holes. After inserting the pin (1),
ensure the flat surface of the pin is resting on the surface of the handlebars.
sting on the floor for a long time.
ATTENTION: Do not leave the machine unattended without first
removing the start-up switch key and applying the parking brake. In
addition, do not park the machine in open places or on sloping floors.
To Next Page
Loading...
