On consignment of the machine
When the machine is delivered to the customer, an
immediate check must be performed to ensure all the
material mentioned in the shipping documents has been
received, and also to check the machine has not been
damaged during transportation. If this is the case, the carrier
must ascertain the extent of the damage at once, informing
our customer service office. It is only by prompt action of this
type that the missing material can be obtained, and
compensation for damage successfully claimed.
Introductory comment
This is a floor scrubber-dryer which, via the mechanical
action of the rotating brush and the chemical action of a
water/detergent solution, can clean any type of flooring. As it
advances, it also collects the dirt removed and the detergent
solution not absorbed by the floor.
The machine must be used only for this purpose. Even
the best machines will only work well if used correctly and
kept in good working order. We therefore suggest you read
this instruction booklet carefully and read it again whenever
difficulties arise while using the machine. If necessary,
remember that our assistance service (organized in
collaboration with our dealers) is always available for advice
or direct intervention.
Serial number plate
TECHNICAL DESCRIPTION UM PE340AS
Rated power W 1260
Working width mm 660
Width of rear squeegee mm 948
Work capacity m
2
/h 2640
Brushes (diameter or length) Ø mm 340
Brush rotations rpm 190
Pressure on the brushes kg 30-40
Brush motor V / W 24/560
Type of advance autom
Maximum gradient % 10%
Movement speed
km/h 0-4
Suction motor V / W 24/1330
Suction vacuum mbar 90
Traction motor V / W 24/150
Solution tank PE l 55
Recovery tank PE l 62
Total machine weight (empty and without
kg 145
Batteries V / AhC5 12/150
Battery weight kg 80
Battery charger V/A 24/15
Battery compartment dimensions (Length / Height /
mm / mm / mm
350x310x325
Machine dimensions (Length / Height / Width) mm / mm / mm
1400x1040x70
Noise level (in compliance with IEC 704/1) dB (A) 59.2
Vibration level m/s
2
1.16
4
To Next Page
Loading...
