MACHINE PREPARATION
10. RECHARGING THE BATTERIES (VERSION WITH BUILT-IN BATTERY
CHARGER)
When replacing the battery, be sure to use batteries suitable for the battery charger installed.
ne. It is not necessary to disconnect it
te
battery charger plug in the mains socket.
The machine is shipped with the battery connector (if supplied) disconnected.
Connect the battery connector to the machi
af rwards, except for maintenance operations.
After switching off the machine, insert the
ATTENTION: For the daily recharging of the batteries, you must
fully respect the indications provided by the manufacture
ATTENTION: The machine is equipped with an automatic
batteries it is essential to avoid their complete discharge: arrange
the recharge within a few minutes of the switching on of the
gnal.
r or
before using the machine again.
system that disconnects the power supply from the electrical
system while the batteries are being recharged.
ATTENTION: In order not to cause permanent damage to the
flashing "discharged batteries" si
ATTENTION: Never leave the batteries completely discharged,
even if the machine is not being used.
retailer. All installation and maintenance operations must be
carried out by expert personnel, trained at the APEC assistance
center.
ATTENTION: Make sure the battery charger green LED is on
ATTENTION: Danger of exhalation of gas and leakage of
corrosive liquids.
ATTENTION: Danger of fire: do not go near with free flames.
11. BATTERY INDICATOR
On the instrument panel of the machine there is a monitor (1) indicating (amongst
edges of the indicators are flashing, this
means the ba
other things) the battery charge status. If the upper line contains 8 light indicators,
the battery charge level is 100%. If the
tteries are run down.
ashed, the brush motor will automatically switch
off. With the remaining charge it is possible to complete the
ATTENTION: A few seconds after the last indicator on the
monitor has fl
drying process before recharging.
1
10
To Next Page
Loading...
