DAILY MAINTENANCE
Clean the hopper as described in the “AT THE END OF THE WORK” paragraph
C rushes;
t g freely. If the brushes are not clean:
L
R
4. heck that there are no wires, bits of plastic or anything else at the ends of the b
hese objects could stop the brushes from rotatin
5. oosen the closure element. (1)
6. elease the splash guard. (2)
7. Remove the idl
8. Remove the br ssemble them.
heck the bristles are not worn; in the event of excessive wear, replace the brushes
(the bristles should be at least 10mm long).
9. Reassemble the splash guards (2), inserting first the hubs (3) in the toothed seat of
the brushes and tightening the closure element (1).
e hubs (3) that support the brushes (4).
ushes (4), clean them with a jet of water, then rea
C
1
2
To Next Page
Loading...
