124
Chapter 8
Customizing the Audio Source Setting AV
Adjusting a blurry or low con-
trast screen
If the screen is blurry or the contrast is low, these
problems can be improved by adjusting the dot
clock.
1 Touch “Pixel Align” in the Initial menu.
2 Touch or to adjust the setting.
Adjust the value so that the dashed lines
appear correctly as three separate lines.
❒ Adjust the value between 0 and 7.
Other Functions
Setup adjustments
(1) System menu display
➲ How to display the System menu ➞ Page 77
Setting the video input
You can switch the setting according to the con-
nected component.
• Select “Video” to watch video of a connected
component as AV-1 or AV-2 source.
1 Touch “AV1 Input” or “AV2 Input” in the
System menu.
Each touch of the “AV1 Input” or “AV2
Input” changes the settings as follows:
AV1 Input:
• Off — No video component is connected
• Video — External video component
• EXT — Pioneer external unit connected
with RCA video cable
AV2 Input:
• Off — No video component is connected
• Video — External video component
❒ When a Pioneer external unit is connected
with an IP-BUS cable, select EXT. When
the audio source is EXT, the “Video
image” of the Pioneer external unit can be
displayed.
❒ Use AV2 Input when connecting CD-
RM10 (sold separately) through the exter-
nal video component.
(1)
Other Functions
CRB2325A_U_English.book Page 124 Wednesday, December 13, 2006 6:58 PM
To Next Page
Loading...
