134
Appendix NAVI/AV
*: Product Number in the Service Info Screen is not
displayed.
About the icon for the memory
navi mode
When new route guidance starts, the route data
from the DVD Map Disc is read into the memory
of the navigation system. The status of the mem-
ory navi mode is indicated by the following icons
on the lower right of the map screen.
(Green flashes): Reading the data
(Green is lit): Operated in memory navi mode
(Red flashes): Operated in memory navi
mode, but the remaining distance for guidance is
less than 12.5 mi.
❒ Where the navigation guidance is impossible,
the icon is lit in red. In that case, reinsert the
DVD Map Disc.
When disappears, memory navi mode is
ready. You can now remove the DVD Map Disc.
❒ If you want to remove the DVD Map Disc while
preparing for the memory navi mode, press
the EJECT button more than 2 seconds.
When the DVD Map Disc is removed, data
cannot be read any more and preparation for
memory navi mode will be canceled accord-
ingly. (Since the reading of the map data used
in the memory navi mode is not complete, the
map scale may switch to a larger scale. In this
case, route guidance will continue up to the
location already memorized.)
In memory navi mode, you will be notified in three
cases: when the distance to the edge of the mem-
orized area is 12 mi (20 km), 6 mi (10 km) and 3
mi (5 km) respectively.
Preparation for memory navi mode will have to be
repeated if the vehicle enters an unrecorded area,
then returns to an area stored in the disc. (Prepa-
ration for the memory navi mode starts from the
location where the vehicle re-entered the area
stored on the disc.)
Major restrictions during the
memory navi mode
• The scale cannot be zoomed freely.
• A detailed city map cannot be displayed.
• If a route was set to your destination in mem-
ory navi mode, inserting the DVD Map Disc
automatically starts recalculation of another
route. (You cannot cancel this reroute opera-
tion. If the route calculation fails for some rea-
son, a message will appear asking you to either
recalculate a route (Reroute) or delete the cur-
rent route (Delete route). In this case, drive for
a while before touching either “Reroute” or
“Delete route” to delete the current route, then
reset the destination.)
• In some cases, you may not be able to use map
display mode during DVD navi mode. If the
map display mode is not changed during
Route Options menu
Edit Current Route –
View Current Route
U
Recalculate –
Number of Routes
✓
Route Condition
✓
Avoid Freeway
✓
Avoid Ferry
✓
Avoid Toll Road
✓
Designate Areas to Avoid –
Settings menu
Volume
✓
System Options
U
Short-Cut Selection
✓
Map Display Options
✓
Defined Locations –
Demo Mode –
Time
✓
Modify Current Location
✓
Hardware Info
U*
Restore Factory Settings
✓
Shortcut menu
: Destination –
: Change Route
U
: Registration
✓
: Vicinity Search –
: Volume Setting –
: Whole Route Overview
✓
: Overlay POI –
: Address Book –
: Route Options
U
: Edit Current Route –
: Traffic On Route –
: Stock Info
✓
: Set My Favorites
✓
: My Favorites
✓
NAVI MENU
CRB2325A_U_English.book Page 134 Wednesday, December 13, 2006 6:58 PM
To Next Page
Loading...
