72
Chapter 5
Customizing Your Navigation System NAVI
Voice Guidance
This setting controls whether the volume of the
Audio source is automatically muted during voice
guidance.
On*:
During voice guidance, the volume of the Audio
source is muted automatically.
Off:
Volume of the Audio source stays the same dur-
ing voice guidance.
❒ When Voice Guidance is “On”, be sure to set
the Mute Input/Guide setting in the AV
MENU to Mute or ATT.
➲ Switching the muting/attenuation ➞ Page 123
System Options
Touch “System Options” in the Settings menu
to display.
Language Selection
➲ The language displayed can be set ➞
Page 130
Once you change the language, installation of
the program starts.
• Once the installation of the program starts,
do not stop the engine of your vehicle and
do not switch off the navigation system
until the installation is completed and the
map of your surroundings appears.
KM/Mile Setting
This setting controls the unit of distance dis-
played on your navigation system.
Mile *:
Show distances in miles.
Mile & Yard:
Show distances in miles and yards.
km:
Show distances in kilometers.
Installation Angle Setup
You can correct the installation angle of the navi-
gation system. Correcting the installation angle
improves the accuracy of sensor learning, even if
the unit is not facing center. Select the orienta-
tion of the LCD panel from the left, centre, and
right. Check the direction the LCD panel faces,
and touch the corresponding item.
“Facing Left”:
Select this when the angle is 5
° or more to the left
from the center.
“Facing Center”*:
Select this when the angle is less than 5
° to the
left and right from the center.
“Facing Right”:
Select this when the angle is 5
° or more to the
right from the center.
❒ If the “Learning Status” in the “3D Calibra-
tion Status” is “Simple Hybrid”, the instal-
lation angle can be corrected.
Average Speed
When calculating expected time of arrival and the
number of hours to the destination, set the aver-
age speed for the freeway or ordinary road using
“+” and “–”.
Minor Ordinary Road
• When the “KM/Mile Setting” is set to “Mile”
or “Mile & Yard”, it can be set in 5 mile incre-
ments from 10 miles to 100 miles (35 miles*).
• When the “KM/Mile Setting” is set to “km”, it
can be set in 5 km increments from 20 km to
110 km (55 km*).
Major Ordinary Road
• When the “KM/Mile Setting” is set to “Mile”
or “Mile & Yard”, it can be set in 5 mile incre-
ments from 10 miles to 120 miles (45 miles*).
• When the “KM/Mile Setting” is set to “km”, it
can be set in 5 km increments from 20 km to
150 km (70 km*).
CRB2325A_U_English.book Page 72 Wednesday, December 13, 2006 6:58 PM
To Next Page
Loading...
