Pioneer AVIC-D3 - Navigation System With DVD Player - How to set your destination by address

24
Chapter 1
Basic Operation NAVI/AV
Inserting/Ejecting a Disc
Inserting a disc
1 Insert a disc into the disc loading slot.
❒ The DVD drive plays one standard 12-cm or
8-cm (single) disc at a time. Do not use an
adapter when playing 8-cm discs.
❒ Do not insert anything other than a disc
into the disc loading slot.
➲ “Playable Discs” ➞ Page 14
❒ If you cannot insert a disc completely or if
a inserted disc is not recognized, check
that the label side of the disc is up. Also,
press the EJECT button to eject the disc,
and check the disc for damage before
inserting the disc again.
❒ If the built-in DVD drive does not operate
properly, an error message such as Error-
02 may be displayed.
➲ “Error Messages” ➞ Page 151
Ejecting a disc
1 Press the EJECT button.
The disc is ejected.
Flow from Startup to Termina-
tion
• If the program is not installed, see page
130 and install the program.
1 Start the engine.
After some time, the navigation opening
screen comes on for a few seconds. Then, a
message screen is displayed.
2 Insert the Pioneer DVD Map Disc to the
disc loading slot.
3 Check the details of the caution message
and touch “OK”.
You can operate the navigation system by
touching keys displayed on the screen.
If the route is already set, it changes to route
guidance mode. The map of your surround-
ings is displayed.
➲ How to read the current position screen ➞
Page 35
➲ Setting the time ➞ Page 131
4 Press the MENU button in the map
screen.
Displays the NAVI MENU.
5 Allows you to assign a destination and
begin route guidance.
➲ Specifying the address and searching the
destination ➞ Page 25
➲ Other search methods ➞ Page 41 to 43
6 Turn off the vehicle engine.
This navigation system is also turned off.
❒ Until the vicinity of the destination is
reached, the set route will not be deleted
even if the engine is turned off.
CRB2325A_U_English.book Page 24 Wednesday, December 13, 2006 6:58 PM