Pioneer GEX-500DVB - After Installing the System

10
1. Reconnecting the battery.
First, double-check that all connections are correct and that the unit is installed correctly. Reassemble all
vehicle components that you previously removed. Then reconnect the negative (-) cable to the negative (-)
terminal of the battery.
2. Start the engine.
3. Display the videos of the DVB-T receiver.
Note: Change the input of the display so that you can display the video of the DVB-T receiver to your
car display system.
4. Enter the required settings: (refer to operation manual)
5. Others
About a CA card (conditional access card) and CAM (Conditional Access Module
After
Installing
the
System
After installing the unit, be sure to check at a safe place that the vehicle is performing
normally.
When you insert a CAM (Conditional Access Module), Keep it horizontally.
When you draw out a CAM (Conditional Access Module), Keep it horizontally.
When CA card (Conditional Access card) and CAM are inserted in this product, CA card
and CAM
protrude from a BOX.
Take well care about an installation position.