Pioneer PD-M430 - Program Playback Management; Programming a Pause; Program Contents Management

TO PLAY ONLY DESIRED TRACKS/DISCS
Programming a pause
Inserting
a
pause
in
your
program
can
be
very
useful
when
carrying
out
recording.
Press
PAUSE
instead
of
entering
a
track
number.
"PA"
appears
on
the
display
panel.
For example, when recording on both sides of a cassette tape,
if you program a pause after the last track to be recorded on
the first side, program playback will pause at that point to
allow you to switch tape sides. To resume program playback
after the player enters pause mode, press PAUSE.
Notes:
e A pause cannot be programmed at the beginning of a program
(P-01), and two pauses cannot be programmed one after the
other.
A pause inserted in a prograrn is counted as one step.
If a pause is programmed as the last step of a program, the
player will not enter the pause mode.
To clear all of the program contents
©
STOR,
stop
CLEA a
Ss
_
A
@
Sf] S
(C3)
® During stop mode, press STOP/CLEAR.
© When the magazine is ejected, the program contents will be
cleared.
To erase a program (PD-M435 only)
Press CLEAR on the remote control unit.
The last program step is erased and the contents of the previous
program step are displayed.
NOTE:
Contents of a program can be erased during playback as well.
However, tracks preceding the currently playing track cannot be
erased in this way.
To check the program contents (PD-M435 only)
= CHECK =
ins 03 P= 0
= CHECK
J-d4 “ P- oe
)
[a]
=
im (a)
ras
Press CHECK on the remote control unit. The program contents
will be displayed in the programmed order.
e After confirming the last program step, the display will show
"0.00".
To modify the program contents (PD-M435 only)
1 =
1. Press CHECK so that the program step to be corrected appears
on the display.
2. To correct the disc No., enter the new disc No. with the DISC
NUMBER buttons. To correct the track No., press Kd or Pt
so that the desired track No. appears on the display. After
correcting the disc No. and /or track No., press PROGRAM.
For example, the programmed track No. 4 on the disc No. 3 is
changed to track No. 7 on the disc No. 5, using DISC NUMBER
5, Bi and PROGRAM.
@ Repeat steps 1 and 2 to change other tracks as desired.
13
<PRB1124>
En