Pioneer PDP-433MXE

30
En
Other Operations
English
4 Press SET to select INPUT 1.
The factory default setting is OFF. Each time SET is
pressed the selector function switches alternately as
shown:
÷ When OFF is selected, AUTO FUNCTION is
disabled.
÷ When INPUT 1 is selected, the display input
automatically switches to INPUT 1 when a signal is
detected at the INPUT 1 jack. Thereafter, the input
will not change even if the INPUT button is pressed
on the remote control unit or display.
Once the function has switched to INPUT 1 by
operation of the AUTO FUNCTION facility, if the
input signal is no longer detected at the INPUT 1
terminal, the function will automatically switch back
to the original input source used before the AUTO
FUNCTION facility was enabled.
5 Following completion of settings, press MENU
again to return the display to its normal screen.
Note
The AUTO FUNCTION for INPUT1 is supported only when a
separate SYNC or composite SYNC analog RGB signal is input.
(When a G on SYNC or component video signal is input, AUTO
FUNCTION is disabled.)
Other Operations
3 OFF
INPUT1 2
Audio Output (AUDIO OUT)
The signal level produced at the AUDIO OUT jack can be
set to FIXED or VARIABLE (linked to the VOLUME) as
desired.
1 Press MENU.
The onscreen menu will be displayed.
MAIN MENU INPUT1
SELECT ENTER EXIT
SET MENU
PICTURE SCREEN SET UP OPTION
:
0
:
6
+
+
+
0
:
60
:
60
:
0
:
0
CONTRAST
:
0
BR
RLEVEL
IGHT.
.
GLEVEL.
BLEVEL.
H ENHANCE.
V ENHANCE.
RSETE
2 Press 2/3 to select OPTION.
SELECT CHANGE EXIT
SET MENU
PICTURE SCREEN SET UP OPTION
:
:
AUTO CT
T
IONNF
AUD I O O
:
U
UFIEXD
OF F
POWER NDSTA ARDRTLONCO
MAIN MENU INPUT1
3 Press 5/∞ to select AUDIO OUT.
SELECT CHANGE EXIT
SET MENU
PICTURE SCREEN SET UP OPTION
AUTO CT
T
IONNF
AUD I O O
:
U
UFIEXD
OF F
POWER NDSTA ARDRTLONCO
:
:
MAIN MENU INPUT1
4 Press SET to select the desired audio level setting.
The factory default setting is FIXED. Each time SET is
pressed, the function alternates as shown:
÷ When FIXED is selected, the audio output volume
will not change, even if the setting of the display’s
VOLUME function is later changed.
÷ When VARIABLE is selected, the level of the output
signal changes in accordance with the setting of the
VOLUME function.
5 Following completion of settings, press MENU to
return to normal screen display.
Note
The AUDIO OUT setting affects all input sources.
3 FIXED
VARIABLE 2