Pioneer PDP-507XDA - Power Management (PC Mode Only); Power Management

Setting up
08
37
En
Power Management (PC mode only)
The system will be automatically placed into the standby mode
when no signal is received from the PC.
1 Press HOME MENU.
2 Select “Power Control” (/ then ENTER).
3 Select “Power Management” (/ then ENTER).
4 Select “Mode 1” or “Mode 2” (/ then ENTER).
5 Press HOME MENU to exit the menu.
Power Management
Selections Off (default) No power management
Mode 1 • Places the system into the standby mode
when no signal is received from the
personal computer for eight minutes.
• Even when you start using the computer
and a signal is received again, the system
stays off.
• The system is switched on again by
pressing STANDBY/ON on the plasma
display or  on the remote control.
Mode 2 • Places the system into the standby mode
when no signal is received from the
personal computer for eight seconds.
• When you start using the computer and a
signal is input again, the system is
switched on.
• The system is switched on again by
pressing STANDBY/ON on the plasma
display or  on the remote control.