Using with other equipment
11
56
En
Using control cords
Connect control cords between the plasma display and other
Pioneer equipment having the t logo to be able to operate the
connected equipment via the remote control sensor on the plasma
display.
After the CONTROL IN terminals have been connected, the remote
control sensors on the connected equipment do not accept
commands from the remote control units. Face the remote control
units to the remote control sensor on the plasma display when
operating the connected equipment.
Note
• Use no-resistance mono mini jack audio cables for SR
connections.
• Make sure that the power is turned off when making
connections.
• Complete all component connections before making control
cord connections.
About SR+
The CONTROL OUT terminal supports SR+ to allow linked
operations with a Pioneer AV receiver. SR+ features functions
such as automatic input switching and DSP surround mode
display.
For more information, see the user’s manual for the Pioneer AV
receiver supporting SR+.
Note
• Use special SR+ cables available from Pioneer for the
connection.
• When using SR+, connect the plasma display directly to the
receiver with the SR+ cable.
• When connected with SR+, the volume of the plasma display
is temporarily muted.
CONTROL
IN
OUT
CONTROL
IN
OUT
CONTROL
IN
OUT
PDP-427XDA (rear)
Mono mini jack cable
To Next Page
Loading...
