EasyManuals Logo

Pioneer PDP-507XDA User Manual

Pioneer PDP-507XDA
62 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #42 background imageLoading...
Page #42 background image
Enjoying DTV broadcasts
09
42
En
6 Select “Yes” to start “Auto Scan” (/ then ENTER).
The tuner starts scanning from channel 6 to channel 69. The
percentage bar shows the progress.
If any new channel is found, it is automatically registered on
the plasma display.
To quit a channel scan in progress, press RETURN. If you
quit scanning halfway, all channels may not be registered
properly. Make sure to repeat scanning again until it is
completed.
Note
You can select “DTV Setup” only while viewing DTV channels.
Once the digital TV signal is scanned, the channel number and
programme name will be shown on the Programme List above
the percentage bar.
Manual Scan
This function is used to add channels to the preset channel list
when a new channel is added to the city or region you live in.
Manual Scan searches for the channel based on the frequency and
bandwidth you request.
1 Press HOME MENU.
2 Select “Setup” (/ then ENTER).
3 Select “DTV Setup” (/ then ENTER).
4 Select “Installation” (/ then ENTER).
The password entry screen appears. Enter your 4-digit
password using buttons 0 to 9.
5 Select “Manual Scan” (/ then ENTER).
A scanning data entry screen appears.
6 Select “Channel No.” (/).
7 Select the RF Channel No. you want to scan (/).
If you enter the correct RF Channel No., the correct
frequency displays. If the correct frequency is not displayed,
check the RF Channel No. you have entered.
8 After entering the correct RF Channel No., select “Start
Scan” (/ then ENTER).
Scanning starts for the designated RF channel.
When scanning is completed, the image on the scanned
channel is displayed.
If scanning fails and no screen appears, you can try to scan the
signal again, or refer to the Signal Level and Quality indicators
to align the antenna to improve your signal reception.
To quit a channel scan in progress, press RETURN.
Note
You can select “DTV Setup” only while viewing DTV channels.
Scan Status 9/69
0
%
Scan Percentage
Signal Strength
Scan Status 9/69
0
%
Scan Percentage
Signal Strength
Channel 9 found...
001
002
003
004
005
006
Channel No.:
9
Frequency : 198500 KHz
Bandwidth : 7 MHz
Signal Level
Quality
100%
100%
Start Scan
SNR dB
Channel No.: 9
Frequency : 198500 KHz
Bandwidth : 7 MHz
Get Channel Success
Signal Level
Quality
100%
100%
SNR 26 dB

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pioneer PDP-507XDA and is the answer not in the manual?

Pioneer PDP-507XDA Specifications

General IconGeneral
BrandPioneer
ModelPDP-507XDA
CategoryMonitor
LanguageEnglish

Related product manuals