EasyManua.ls Logo

Piper 6XT - CABIN AND COCKPIT GROUP

Piper 6XT
1190 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
THE NEW PIPER AIRCRAFT, INC.
PA-32-301FT / 301XTC
MAINTENANCE MANUAL
PAGE 9
Feb 19/04
1D3
5-20-00
5. Scheduled Maintenance - PA-32-301FT Piper 6X (S/N’s 3232001 & up) (continued)
Inspection
NATURE OF INSPECTION Interval (Hrs)
50 100
B. ENGINE GROUP (CONT.)
42. Inspect condition and tension of alternator drive belt.
(See Adjusting Alternator Belt Tension, 24-30-00.) ............................................... O O
43. If installed, inspect condition of A/C compressor belt and tension.
(See Adjusting Drive Belt Tension, 21-50-00.)....................................................... O O
44. If installed, check A/C compressor oil level. (See Note 9.).................................... O
45. If installed, inspect A/C compressor clutch security and wiring. (See Note 10.) ... O
46. If installed, inspect A/C compressor mounting for cracks, corrosion,
and security........................................................................................................... O
47. Check fluid in brake reservoir. Fill as required....................................................... O O
48. Inspect and lubricate all controls. (Refer to Lubrication Chart, 12-20-00.)............ O
49. Complete overhaul of engine or replace with factory rebuilt...................
50. Install engine cowl................................................................................................. O O
C. CABIN AND COCKPIT GROUP
1. Inspect cockpit and cabin doors, latches, and hinges, and windows, and
aft baggage compartment door, latch, and hinge for damage, operation,
and security........................................................................................................... O
2. Inspect windows for scratches, crazing, and condition.......................................... O
3. Check window and door seals for deterioration, cracks, and voids....................... O
4. Inspect upholstery for tears................................................................................... O
5. Inspect seats, seat belts, shoulder harnesses, security brackets, and bolts.
(See Seat Belt and Shoulder Harness Inspection, 25-10-00.) .............................. O
6. Inspect trim operation............................................................................................ O
7. Inspect rudder pedals............................................................................................ O
8. Inspect parking brake valve and brake handle for operation
and cylinder leaks ................................................................................................. O
9. Inspect control wheels, column, pulleys, cables, turnbuckles, and fittings.
(See Note 11.)....................................................................................................... O
10. Inspect flap lever to control cable attachment bolt for condition and security.
(See Note 11.)....................................................................................................... O
11. Check landing, navigation, strobe, cabin, and instrument lights ........................... O O
12. Inspect instruments, lines, and attachments. ....................................................... O
13. Inspect gyro operated instruments and electric turn and bank.
(Overhaul or replace as required.) ........................................................................ O
14. Replace central air filter......................................................................................... O
15. Clean or replace vacuum regulator filter ............................................................... O
16. Inspect altimeter and transponder for installation/certification per latest
revision of AC43.13-1 and tested/inspected
per FAR’s 91.411 and 91.413, respectively .......................................................... O
17. Inspect and test ELT per FAR 91.207. (See Testing ELT, 25-60-00.)..................... O
18. Inspect operation of fuel selector valve. ................................................................ O
As req’d by Lycoming
Svc Instr. No. 1009

Table of Contents

Related product manuals