Page 35 of 37
Address Counter
ADDRESS LAYOUT
ADDRESS RECOVERY The process of reprinting specific addresses damaged by jams
or printing problems.
Bar Width Width of the bar in a postal barcode.
BARCODE Generic for any scan-able symbology.
BARCODE LOCATION Location option of Above, Below, Lower Right for POSTNET™
barcode in USPS lexicon.
BOLD Applicable Font characteristic.
BRAND Branding channel information for installation by service.
Break Char Count Number of times break sequence must appear.
Break Character Specifies character string to use as break sequence.
BREAK LOCATION Break before or after piece with break information.
Brk Pause Time Amount of time to wait before restarting processing when a
break is encountered.
BUNDLE BREAK A break in mail processing located at a bundle interface
(specified by setting data).
CALIBRATE SENSORS A command to conduct the automatic calibration of the specified
sensor.
Capture Overlay A command to capture the next piece as an overlay image.
CHAR ORIENTATION In DOS mode can specify if the characters occur in a vertical
sequence.
Clear address +YES
Clear Counter Clears the batch counter (customer action).
Clear Memory Clears internal memory(usually associated with the
communication buffer.
Clear Overlay Clears internal memory associated with storing an overlay.
Communication buffer The internal buffer that stores pending information from the print
stream.
Conveyor On time
CONVEYOR SETUP
CONVEYOR TYPE
Courier A font name.
CR=CR LF=LF Options for line termination; CR- Carriage Return, LF- Line
Feed.
DHCP
Distance from Left
Draft (200) A print quality selection.
Executive (600) A print quality selection.
Exit Sensor
FEED GAP
Feed Gap Distance
FEED GAP TYPE
Feeder Sensor
FEEDER SETUP
FEEDER SIGNAL
FEEDER TYPE
FONT NAME The name of a specific internal font.
FONT SIZE The selected point size for a specific internal font.
Gateway Address
To Next Page
Loading...
