Page 36 of 37
Get Addr (batch)
Get Addr (inter)
Hex Dump
IMAGE OVERLAY
INK CARTRIDGE
VOLUME
The milliliters (ml) of ink contained in the cartridge when full.
Ink Count The amount of ink (drops) printed from the cartridge since new.
INVERTED PRINTING Inverting the entire image to be printed on the piece.
IP Address Part of the network setup when using ethernet communications.
ISO CHARACTER SET see Symbol Set.
ITALIC A settable font characteristic (DOS mode only).
JOB SETTINGS
LANGUAGE
Letter (300) A print quality selection.
LIGHT MODE A mode where vertical is altered from 600 dpi to 300 dpi by not
firing the second column on the print cartridge.
LINE SPACING Used for DOS mode only sets lines per inch spacing.
LINE TERMINATION Specifies character combinations to use as line termination
sequence.
Lines per address The number of lines that all addresses have (DOS only).
Logging Settings Logs (if available) may have multiple levels of depth of event
logging.
LOW INK WARNING The value at which the printer will show a low ink warning
message. Shown in % of ink volume for specific cartridge.
MAINTENANCE COUNT Total cycle count on hardware since new.
MODULE DISTANCE
NOZZLE KEEP ALIVE Mode where printer spits single nozzles on ‘random’ pattern.
ORIENTATION CONTROL
Paper Sensor Sensor before first print module used to control and trigger
printing.
PERIODIC PURGE A purge that happens on a time scheduled basis during while
printing a job.
Port Number
PRE-PURGE aka PURGE AT START. A purge run before starting a job.
PRINT BREAK CHARS
PRINT HEAD ADJUST
Overlay A overlay graphic added to each piece while printing.
PRINT QUALITY Selected DPI value.
Pulse Time (msec)
PURGE AT START aka PRE-PURGE. Run a purge prior to start of printing a job.
Purge Interval Time between purges when a periodic purge is active.
Head assembly. Assembly that is raised or lowered by Media thickness
adjustment knob.
Raise paper guide.
Rising Edge
ROM Revision # Version number for firmware installed in printer.
Signal Polarity
Stacker Output stacker selection option.
Standard Feeder
STOP ON FEED ERROR
To Next Page
Loading...
