Pitney Bowes FastPac DI950 - Assigning User Ids and Passwords; Enabling and Disabling the High Capacity Sheet Feeder; (Hcsf)

SV61311 Rev. E
4-5
Advanced Operation • 4
Assigning
User IDs and
Passwords
You must have Manager level access rights to assign a user ID and pass-
word.
1. From the Home screen, select "Menu" and then "Tools."
2. Select "Configure System" and then "Security Level."
NOTE: If you are not logged in with supervisor or manager access rights, you
will be prompted to enter an access code.
3. The Security screen displays. Select "User ID Setup."
4. Select "Add New User."
5. The Enter User Name screen displays:
a. Use the alphanumeric matrix to enter the user ID.
b. Select "Finished" when done.
6. The Select User Level screen displays:
a. Use the UP/DOWN arrow keys to select the appropriate access level
(operator, supervisor, or manager.)
NOTE: Refer to Access Rights in Chapter 2 of this guide for more infor-
mation.
b. Select "Accept User Level" when done.
7. The Enter Password screen displays:
a. Enter the password.
NOTE: Passwords are four-digit numeric codes. Numbers 1, 2, 3, 4 and
5 display on the rst screen. Press "Next" to access numbers 6, 7, 8, 9,
and 0.
b. Select "Finished" when done.
Enabling and
Disabling the
High Capacity
Sheet Feeder
(HCSF)
Follow the steps below to enable or disable the HCSF.
1. On the control panel, enable the Upper and/or Lower Feeder Trays.
2. From the Home screen, select "Menu", "Tools", then "Configure System",
and finally "Tools".
3. Select “Enable” or "Disable" for the Feeders that you want.
4. Select "Accept", and then press HOME.