Pitney Bowes J693 - Resetting the Printer

J693 17
4.0.6 Resetting the Printer
Depending upon the method used, there are three reset levels possible:
4.0.6.1 Soft Reset
To reset the printer and clear any temporary host settings:
n With the printer ‘On’, press and hold the CANCEL key for approximately
four seconds.
4.0.6.2 Level 1 Reset
To return the printer to the factory default settings:
n Turn ‘Off’ the printer.
o Press and hold the PAUSE and CANCEL keys while turning ‘On’ the
printer; continue to depress the keys until the ‘SYSTEM RESET’ message
flashes.
;
;
Note:
This reset can also be executed using the menu system: System
Settings/Set Factory Defaults. See Section 4.1 for a listing of the
factory default settings.
4.0.6.3 Level 2 Reset
To return the printer to the factory default settings, and clear all the calibration
and adjustment parameters:
n Turn ‘Off’ the printer.
o Press and hold the PAUSE, FEED, and CANCEL keys while turning ‘On’
the printer; continue to depress the keys until the ‘SYSTEM RESET’
message flashes.
;
;
Note:
After executing a Level 2 Reset, both Ribbon and Media
Calibrations must be performed; see Sections 5.1 and 5.2. See
Section 4.1 for a listing of the factory default settings.