Setscrews are used to secure axles inside the hubs of wheels, collars, and connectors.
Shaft Servo Hub 40230
Wheel with Tire (90 mm) 40222
80-Tooth Plastic Gear 40224
40-Tooth Plastic Gear 40223
D-Shaft Set Collar 40229
16 mm Ball Skid Point 41260
Beam Attachment Hub 40228
TIP: Because some parts from the
TETRIX PRIME R/C Starter Set might already
have Socket Head Cap Screws installed, the
directions for the expansion builds might
or might not show installing Socket Head
Cap Screws. Please keep in mind that if your
parts already have Socket Head Cap Screws
installed and the directions call for that
operation, you can skip to the next step.
TIP: Directions will show these types of parts
in proper position. Please remember after the
parts are in place to tighten the Socket Head Cap
Screws before moving to the next step.
TIP: Socket Head Cap Screws should be snug
but not overtightened. Overtightening Socket
Head Cap Screws can damage components.
Introduction to Building with TETRIX PRIME 17
To Next Page
Loading...