Introduction to myRIO and LabVIEW™ Graphical Programming
myRIO Overview
NI myRIO is an embedded hardware device designed for students and based on technology used in industry for controls
and robotics. It has all the I/O and processing power you need to control the systems you create using this kit and more!
Using myRIO you can . . .
• Implement simple to complex controls algorithms such as PWM and PID
• Communicate over Wi-Fi to control and monitor your robot remotely
• Deploy programs to allow your robot to run autonomously
• Use the motor board to interface with all the sensors and actuators in this kit
. . . and much more! To learn more about myRIO, visit ni.com/myrio.
Xilinx Zync FPGA
and dual-core ARM
Cortex-A9
40 lines of digital I/O
with SPI, I2C, UART, PWM,
encoder, etc.
10 Analog Input
6 Analog Output
USB and Wi-Fi
integration
32 Introduction to myRIO and LabVIEW™ Graphical Programming
Back to Contents page
To Next Page
Loading...