DC Motor Mount Assembly
1x
Digilent
Motor Shaft
Adapter 41139
1x
Digilent DC
Gear Motor
41143
1x
DC Motor
Encoder Cap
41231
1x
Digilent DC Motor
Mount 41138
Parts Needed
2x
Setscrew 40516
Step 1
Step 2
Step 4Step 3
After unpacking the Digilent DC Gear Motor, inspect the
electronic components on the encoder board before
snapping the encoder cap in place. If components appear to
be bent, carefully bend them back up straight to ensure that
they are not touching the spinning center magnet.
26 Subassembly Construction Instructions
Back to Contents page
To Next Page
Loading...