Piusi CUBE B.SMART - Machine and Manufacturer Identification; Position of the Plates

11/124
EN
11 /6 0
This manual belongs to PIUSI S.p.A. The reproduction of all or parts is prohibited.
CUBE
EN (translated from Italian)
3
APPLY THREAD
SEALANT
TO THE
CONNECTORS
BEFORE FINAL
ASSEMBLY
8 MACHINE AND MANUFACTURER IDENTIFICATION
The CUBE B.SMART stations are equipped with an identification plate
attached to the frame:
- Model
- Serial number / year of manufacture
- Technical data
- CE marking
- Manual code
IMPORTANT
Before installation, always check that the dispensing system model
is correct and suitable for the supply currently available (Voltage /
Frequency).
8.1 POSITION OF THE PLATES
Some stickers and/or plates are applied to the distribution system to
indicate the most relevant information to the operator. It is necessary to
check that these do not deteriorate or detach over time.
NOTE
Should this occur, please contact our customer assistance office so
that we can send you copies of the spoilt or missing plates/labels for
reapplication where originally provided.
The following labels are present:
ON
OFF
1
- Pump operation plate.