Pixsys ATR144 - Page 58

58 - ATR144 - User manual
digital input 1 is active.
d.i. 2 Digital Input 2. Active when
digital input 2 is active.
rEM. Remote. The alarm is enabled
by the word 1220
P. a u x Auxiliary 1 for cycle (programmer
version only)
63 A . I. 5 . o . Alarm 1 State Output
Alarm 1 output contact and intervention type.
n.o. S t. (N.O. Start) Normally open,
active at start (Default)
n.c. S t. (N.C. Start) Normally closed, active at start
n.o. tH. (N.O. Threshold) Normally open,
active on reaching alarm
2 p. 86
n.c. t H. (N.C. Threshold) Normally closed,
active on reaching alarm
2 p. 86
64 a .1 . H y . Alarm 1 Hysteresis
Alarm 1 hysteresis
-9999..+9999 [digit
1 p. 86
] (degrees.tenths for temp.
sensors). Default 0.5.
65 A.1.L. L. Alarm 1 Lower Limit
Lower limit selectable for the alarm 1 setpoint.
-9999..+30000 [digit
1 p. 86
] (degrees.tenths for temp.
sensors). Default 0.
66 A.1. u.L. Alarm 1 Upper Limit
Upper limit selectable for the alarm 1 setpoint
-9999..+30000 [digit
1 p. 86
] (degrees.tenths for temp.
sensors). Default 1750.
67
a .1 . r e . Alarm 1 Reset
Alarm 1 contact reset type
A. rEs. Automatic reset (Default)