42 - ATR144 - User manual
9.2.d Master reading mode CT 2000.35.014 as
amperometer
To enable this operation, En . ct.A. should be set on the
parameter 160 mb.ma.
If you connect the current transformer to the serial port, the
RMS current measured will be the process of the ATR144: by
means of this mode the device will become an ammeter.
10 Reading and confi guration through NFC
Scan the Qr-Code
to download the App
on Google Play Store®
The controller ATR144 is supported by the App MyPixsys: using
an ANDROID smartphone with NFC connection it is possible
to program the device without using a dedicated equipment.
The App allows to read, set and backup all parameters which
are stored into the internal memory of Pixsys devices.
Procedure:
• Identify the position of the NFC antenna on the
smartphone (usually central, behind the back cover) or
to one of the sides in case of metal chassis. The ATR144’s
antenna is placed on the frontal panel, under the UP arrow
keys.
• Make sure that the NFC sensor of the phone is enabled or
that there are no metal materials between the phone and
the device (ex. aluminium cover or with magnetic stand)
To Next Page
Loading...
