Planar RPS - Page 35

RS232 Codes
Planar RPS and Video Controller RS232 User Guide Page | 35
020-1332-00I
ZONE.EXPECTED.
SOURCE.HEIGHT
Zone Source
Height
2617 =? Integer Integer ZONE.EXPECTED.SOURCE.
HEIGHT(3)?
ZONE.EXPECTED.SOURCE.
HEIGHT(3):2160
Gets / sets the input resolution height of
the zone source. Only applicable to the
active display/preset.
No 4.0 Yes No
ZONE.EXPECTED.
SOURCE.WIDTH
Zone Source
Width
2616 =? Integer Integer ZONE.EXPECTED.SOURCE.
WIDTH(3)?
ZONE.EXPECTED.SOURCE.
WIDTH(3):3840
Gets / sets the input resolution width of the
zone source. Only applicable to the active
display/preset.
No 4.0 Ye s No
ZONE.FRONT Send Zone to
Front
2614 =? Integer ZONE.FRONT=2
ZONE.FRONT:2
Gets / sets the zone at the top of the zone
overlapping display area for the active
display.
No 4.0 Yes No
ZONE.ID Set Zone ID 2601 = 1-65535 1-65535 ZONE.ID(5)=3
ZONE.ID(5):3
Sets an existing zone ID to a new zone ID. If
there are duplicate IDs, the first found will
be changed. Only applicable to the active
display/preset.
No 4.0 Ye s No
ZONE.INPUT Assign Input to
Zone
2602 =? Integer VC#.IN# ZONE.INPUT(5)=VC2.IN3
ZONE.INPUT(5):VC2.IN3
Gets / sets the source input for a specified
zone. Only applicable to the active
display/preset.
No 4.0 Yes No
ZONE.JUSTIFY Justify Zone 2611 =? 1-65535 0=CENTER
1=LEFT
2=RIGHT
3=TOP
4=BOTTOM
5=TOP.LEFT
6=TOP.RIGHT
7=BOTTOM.LEFT
8=BOTTOM.RIGHT
ZONE.JUSTIFY(3)?
ZONE.JUSTIFY:TOP.LEFT
Gets / sets the reference edge(s) of a zone
source. Only applicable to the active
display/preset.
No 4.0 Ye s No
ZONE.LIST Zone ID List 2603 ? Integer 1-ZONE.COUNT
…..and/or….
Integer 1-ZONE.COUNT
String ZONE.LIST?
ZONE.LIST:1 2 3 5 6 7 8 9 10
ZONE.LIST(3)?
ZONE.LIST:3
ZONE.LIST(4 8)?
ZONE.LIST:4 5 6 7 8
Returns a list of zone IDs associated with
the active display. The optional modifiers
enable listing when there are more than 64
zones. The first modifier gives the 1-based
index into the list for the first returned
value. If the second modifier is omitted,
only one value is returned. When given, the
second value specifies the end index of the
returned values.
No 4.0 Yes No
ZONE.MAXIMIZE Maximize Zone 2604 ! Integer ZONE.MAXIMIZE(3)
ZONE.MAXIMIZE:@ACK
Sets a zone to display an image over the
entire active area controlled by the system.
Only applicable to the active
display/preset.
No 4.0 Ye s No
Command Description
Numeric Command Code
Operators
Modifiers Operands Example Notes
Standalone Component Command
Firmware Version Active
Functional in Fast Start Standby
Functional in Low Power Standby