24
2.2 Mounting Installation
This section describes how to install the Industrial Gigabit Ethernet
Switch and make connections to it. Please read the following topics and
perform the procedures in the order being presented.
Note
In the installation steps below, this Manual uses
IGS-801 (PLANET 8 Port Industrial Gigabit Switch) as
the example. However, the steps for PLANET Industrial
Switch & Industrial Media Converter are similar.
2.2.1 Installing DIN-rail Mounting
The DIN-rail is screwed on the Industrial Gigabit Ethernet Switch when
out of factory. When replacing the wall mount application with DIN-rail
application, Industrial Gigabit Ethernet Switch is needed. Please refer
to the following gures to screw the DIN-rail on the Industrial Gigabit
Ethernet Switch. To hang the Industrial Gigabit Ethernet Switch, follow
the following steps:
Step 1: Screw the DIN-rail on the Industrial Gigabit Ethernet Switch.
To Next Page
Loading...
