16
4. Connecting And Using The VDSL2 Bridge
The Ethernet to VDSL2 Bridge does not require any software
conguration. Users can immediately use any feature of this
product simply by attached the cables and plug power on. There
is some key limitation on the VDSL2 Bridge. Please check the
following items:
¾ The device can be used for Point-to-Point (one CO device
to one CPE device) connection or Point-to-Multipoint (one
multi-port CO device to multi CPE devices) and allows data
and voice work on the same telephone lines.
¾ The VC-231G provides only one RJ11 connector for VDSL2
port to build VDSL2 connection. For voice device connection,
there is an additional splitter from VC-231G packages is an
idea choice.
¾ The VC-234G provides two RJ11 connectors for VDSL2 port.
One for voice device connection (like telephone) and the
other one for VDSL2 network link connection.
¾ Depending on the quality of telephone line, the maximum
distance of one VDSL2 segment is 1.4km (4593ft) with AWG
24 telephone wires. The distance could vary on the quality of
telephone wires.
To Next Page
Loading...
Need help?
General
