Planmeca ProSensor 1
INTRODUCTION
User’s Manual
1 INTRODUCTION
This manual describes how to use and install the
Planmeca ProSensor sensor that is intended to be used
for capturing digital intraoral x-ray images from patient’s
jaw, teeth, gums, roots and root canals by trained dental
care professionals.
Please read this manual carefully before using the
system.
Planmeca ProSensor automatically triggers and captures
images to the start and end of the x-ray radiation so that
any intraoral x-ray unit supporting exposure times and
cones listed in tables of chapter “Exposure values for
Planmeca ProSensor” can be used.
The Planmeca Romexis imaging software or third party
software stating compatibility with Planmeca ProSensor
or software stating compatibility through TWAIN can be
used for image capturing.
Planmeca ProSensor is connected to a computer using
Ethernet or USB interface and it supports Windows and
MAC operating systems, see details in section
“TECHNICAL SPECIFICATIONS” on page 18.
This manual is valid for following software revisions:
• Planmeca ProSensor Ethernet software version 2.1.0.R
or later
• Planmeca ProSensor USB software version 2.2.1.R or
later
• Didapi software version 4.8.1or later.
To Next Page
Loading...
Need help?
General
