EasyManua.ls Logo

Plasmapp Sterlink FPS-15s Plus - User Manual

Plasmapp Sterlink FPS-15s Plus
65 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Language: EN
STERLINK
®
FPS-15s Plus Plus User Manual
FPS-15s Plus (FPS-15s
+
)
User Manual
Low-temperature plasma sterilizer
by Plasmapp Co., Ltd.

Table of Contents

Questions and Answers

  • J
    John MilesAug 10, 2025
    What to do if Plasmapp Sterlink FPS-15s Plus shows initializing error?
    • E
      Erika AllenAug 10, 2025
      An initializing error in Plasmapp Laboratory Equipment may occur if the chamber door is open. Also, check the cleanliness of the scanner glass inside the sterilizer chamber. The error can also occur if the cassette is re-used, expired, or invalid; in this case, try again with a new cassette.
  • J
    Jorge JohnsonAug 26, 2025
    What to do if Plasmapp Sterlink FPS-15s Plus shows too much moisture in the load?
    • M
      mitchellgreenAug 26, 2025
      If your load prepared has too much moisture, an error message can be displayed, which stops the sterilization cycle. The load should be dried, and you can try again with a new cassette.

Plasmapp Sterlink FPS-15s Plus Specifications

General IconGeneral
BrandPlasmapp
ModelSterlink FPS-15s Plus
CategoryLaboratory Equipment
LanguageEnglish