Plasmapp Sterlink FPS-15s Plus - Troubleshooting; System Features

Rev. 03 / Jan. 2019
Plasmapp Co., Ltd.
STERLINK
®
FPS-15s Plus User Manual
50
Chapter 9. Troubleshooting
Most sterilizer operating problems are accompanied by a system message. These messages are
useful in determining the source of the problem. In many cases you can take remedial actions to
correct the source of the problem and thereby return the sterilizer to normal operation. In other
cases, the problem is caused by a component failure that requires adjustment or repair by the
manufacturer or the local Plasmapp customer support representative. If you are unable to identify
the cause and solve the problem, please contact Plasmapp or your local Plasmapp customer
support representative.
9.1. System features
The STERLINK
®
FPS-15s Plus sterilizer system can perform the fully automated sterilization
cycle. The system can display self-status with LED light of green, blue, and red at the following
status.
LED Color
System status
Green
Ready for the sterilization (Blinking during preheating process)
Blue
Sterilization cycle is completed. (Blinking during sterilization cycle)
Red
Blinking when the error occurs.
Figure 9.1 Sterilizer status with different LED colors