Plasmapp Sterlink FPS-15s Plus - Software Update

Rev. 03 / Jan. 2019
Plasmapp Co., Ltd.
STERLINK
®
FPS-15s Plus User Manual
51
9.2. Software update
The STERLINK
®
FPS-15s Plus sterilization system will be automatically updated by the
Plasmapp when the user confirms this update. If the system finds a new software version at the
ITS
TM
server, the following alarm will be popped up when the system is restarted.
When the user confirms this software update, it will take several minutes for completing the
update and the system will be rebooted when completed. The update may be failed by the unstable
internet connection and can be postponed depending on the user.
Figure 9.2 GUIs for software update confirm and updating
Number
Name
Description
1
Confirm
This icon is for confirming the software update.
2
Cancel
This icon is for postponing the software update.
CAUTION! POSSIBLE DAMAGE ON THE STERILIZER.
The power-off during the software update may damage the sterilizer system. If it
happens, contact the local Plasmapp customer service representative.