3. Close the panel unit by pushing it back down until it snaps back into place.
4. Horizontally load the plastic card, headfirst and face up, toward the center of
the ADF.
Make sure to load the embossed face of the embossed card face up into the
scanner.
For double-sided scans, load the card in desired order.
5. Adjust the paper width slider to the card width. The paper width slider should be
gently touching both sides of the card.
Attention
Make sure the plastic cards you wish to scan
are horizontally loaded into the ADF.
Maximum thickness of each plastic card is
1.2 mm.
64
To Next Page
Loading...
